DarwinFPV ApeStyle D5 Lite

DarwinFPV ApeStyle D5 Lite is a 5" frame suitable for building a freestyle 6S FPV drone. It is the basic version of the ApeStyle D5 frame – it includes the frame itself with 3D-printed parts, without the LED board and protective covers included with the Standard version. The motor-to-motor diagonal is 220mm and the frame weighs 145,3g (±5g).

The arms are cut from 5mm carbon and each is individually replaceable, so only the damaged arm needs to be replaced after a crash. The arm roots are reinforced and fit into the body with a tongue-and-groove joint, ensuring a tight fit and better resistance to breakage. The bottom plate is 2,5mm thick, while the middle plate and camera side plates are 2mm thick. The top plate is extended to accommodate higher-capacity batteries.

The frame provides 25mm of stack height with 30,5x30,5mm mounting holes. The video transmitter mounts in holes with 20x20mm or 25,5x25,5mm spacing and also has 25mm of height available. A 20mm wide camera fits between the side plates. Motors are mounted using 16x16mm mounting holes. The manufacturer recommends DarwinFPV 2207–2507 motors, an ESC with a continuous current rating of at least 50A, Gemfan 51499-3 propellers, and a 6S 1500mAh battery with an XT60 connector. The recommended take-off weight is 500–800g.

At the front of the frame is a 3D-printed mount for a GPS module, positioned as far as possible from the video transmitter to prevent interference. The GPS module itself (DarwinFPV M1018) and LiPo strap are not included and are sold separately. The package also includes a 3D-printed antenna mount, a set of screws, zip ties, and a sticker.